...
Sulu V2 boards
L19 had noticeable epoxy deformation on Quik-Pak SCuM.
L17 had a noticeable crack in the epoxy.
Pin headers soldered on by Digicom
No current drawn from either board from any location.
Both SCuM were confirmed 1 day earlier to successfully program with 3WB using the probe station.
...
L24/L25:
Digicom Assembly Steps:
Clean board and bake it to get rid of moisture
Print solder paste onto board
Use a machine to place smd components
SCuM placed by hand
Use oven to reflow.
Use no clean solder so there is no need to clean it again
Check if the board needs to be touched up
Both boards could be programmed to communicate with Open Mote when received from Digicom
No through hole components/pin headers were added initially
L25 has pin headers added.
Confirmed to work with 3WB and UART
View file | ||
---|---|---|
|