...
Minutes
TODOworking code
where will be using?
<I’m missing the context entirely, please fill in? (Thomas Watteyne )
nRF integration discussion
big board and small board pin interface if different
small board: voltage sources
big board: only
discussion about using P4 for connecting to the McCoy
4x bus for the 3-wire bus
VDDD
VBAT
VDDIO
GND
keep the tap feature
would recommend doing chip-on-board for large board
shipped board to Quik-Pak, waiting for response
bad radio performance on big board with rubber ducky on SMA
bad radio performance
strange, if you are getting -60 dBm, no reason for bit corruption
Fil Maksimovic : same calibration → yes
Kristofer PISTER disable all of the switching regulators and drive with clean external supply to VBAT and VDDIO?
Joshua Alexander yes
Kristofer PISTER susceptibility on noise on supply at certain frequency
Joshua Alexander you can using the pins for the current measurement
Austin Patel this needs to work before sending to Quik-Pak
discussion about changes to layout
goal is to get both boards out by
board review on or
Kristofer PISTER what
Thomas Watteyne to confirm UART pins can be mapped to any pins