Austin Patel
Setup a call to reproduce the QuickCal @??
Titan Yuan use Freq_sweep for BLE to calibrate
Setup a call to do code organization Alex Moreno Brian Kilberg
Updates on QuickCal
Calibrate all frequency settings for Tx and Rx within 3 minutes
The calibration result shows on average the PDR is >80%
On some channel at some run, the PDR could drop to 30%
Other updates
Port OpenWSN over SCuM3C works [EWSN 2020 demo]
6TiSCH on SCuM paper need to resubmit
QuickCal algorithm paper [WIP]
Goal to have a network of two SCuM nodes and one gateway
Work on lighthouse localization
Try to build a motion detect system, needs to turn VDD to make SCuM to send packets
VDD too high/ too low influence SCuM to get/send IMU data packets
Currently transmitting location date on a single 15.4 channel. SCuM-3C TX frequency set via hard-coding in software after a full frequency sweep with openmote reporting which packets it hears, and Brian picking out the “best” frequency setting
Austin Patel
Trying to get an RX/TX working for a micro robot paper deadline March 1.
Choices: modify Brian’s code to calibrate RX, or set up Tengfei’s code to get both
Tengfei Chang use mine - it will take less than an hour
Integrating BLE code into OpenWSN framework
BLE TX frequency is calibrated using LO counter and optical interrupts during programming
Trying to run 15.4 RX, and then BLE TX (to demonstrate bridging from an OpenWSN network to a cell phone)
Andrew Fearing working on getting the ADC working for on-mote feedback control applications
Try to find out a time to organize code