@Jinyue zhu
@Eric Tsang
@jesscia Malow
Update on @Jinyue zhu
using the nRF5340 to implement the 3 wire programming
Thomas Watteyne we should using the timer to arm when to sending each bits, rather than using while loop.
Austin Patel Does nRF5340 PDK provide 1.5 and 3.3 voltage for SCuM?
nRF5340 support both IEEE802.15.4 and BLE
Have a better workable optic programmer is cool, along side with 3 wire programming. Also it’s worth to have for project like hornet tracking.
Ideally, we only need one cable to be connected the nRF5340 PKD + SCuM dev board
The nRF52840 DK is recommended over nRF5340 PDK
We need make sure if there is a way for nRF5340 provide voltage to 1.8 or 1.5 V voltage.
Said Alvarado-Marin the chip provides a register to control the output voltage of the board.
We need make sure the board doesn’t start with a voltage higher than 1.8/1.5 V voltage.
Austin Patel Will the UART work with 1.5/1.8 V voltage?
Said Alvarado-Marin shows the prototype of DotBot V1.1
Austin Patel show the gripper with SCuM
The gripper will trigger the movement when a packet is received from an OpenMote.
There is a space for SCuM on the gripper board, which will be integrated in future.