Issues
- Thomas Watteyne
Board/Chip | Issue Type | Issue Description |
Q2 | Board/Assembly | VDDD and HARD_RESET do not seem connected. Soft and Hard reset are low. Does not boot- Alex |
Q3 | Board/Assembly | soft reset is disconnected |
Q6 | Chip | didn’t run ROM, but booted OK |
Q7 | Chip | sometimes skips character in uart |
Q9 | Board/Assembly | Poor contact between QFN package and board. Pressing on the chip gives noticeable issues with UART communication. |
Q8 | Board/Assembly | GPIO1 stuck low; likely an assembly issue (soft reset was stuck low - likely shorted while soldering something else-fixed) |
Q6 | Chip | Serious issues for optical calibration; interrupt goes off 1-4 times, tops, out of 50x SFD sent |
Q5 | Chip | Used to program fine, now can't get the thing to program. Possibly related to the SMA connector? Just kidding, it's just my computer. |