Attendees

• Dillon Acker-James

• @Andrew Fearing

• @Austin Patel

• @Jackson Paddock

• @Kristofer PISTER

• @Timothy Claeys

• @Tengfei Chang

• @Thomas Watteyne

Minutes

• @Austin Patel

  • Sensor paper accepted! (which one?)

  • update on the hornet battery testing

    • presents a battery with two conductive plastic stick on both side, it’s hard to tap on to the battery.

    • Conduct current test with 4 different load resistors to the battery

      • The voltage and current measure does not match, need to be checked

    • Able to get SCuM to transmit frame with the battery, OpenMote received it. (USB is connected to get UART, need to check if that affects the voltage , see following)

    • @Jackson Paddock SCuM is powered through VBAT, when the USB is connected, does the VDDIO will affect the voltage of SCuM used?

  • @Kristofer PISTER is that possible to have the battery holder as part of the PCB?

  • @Thomas Watteyne are we going to use a chip antenna or just a wire-bonded antenna?

  • we need new SCuM dev boards! several SCuM dev boards are not working.

• @Tengfei Chang update on the SCuM

  • have the SCuM sending BLE iBeacon and received on Phone

  • working on demostrate AoA working on nRF5340 chips

• @Thomas Watteyne go through the idea of tracking hornet using the BLE AoA.

• @Thomas Watteyne update on the laser cutting course and idea of dot bot.

  • update on the hornet news, glue on the front rather than the back.