Testing notes can be found at: https://docs.google.com/spreadsheets/d/14XAfxGwL6wk_KUb9GTKfo5KeL4-N5aEMuYoCTwm1jF0/edit?usp=sharing
L6/L7:
Sulu V1 boards
Immediately after getting boards from Digicom:
...
Both boards could be programmed to communicate with Open Mote when received from Digicom
No through hole components/pin headers were added initially
L24 has pin headers added and L25 has pin headers and SMA connector added after process below.
View file | ||
---|---|---|
|
Austin and Josh testing results:
View file | ||
---|---|---|
|
L2/L3/L4/L5/L11/L12/L13/L18/L31/L37/L43/L49
Confirmed to work with 3WB and UART
...
Assembled by Digicom using low temperature solder and no pin headers or through-hole SMA connector.
Before adding headers/SMA connector optical bootloader boot testing
L11/L12/L13/L18/L31/L37/L43/L49
Booted using optical bootloader
Normal current profile for AllGPIOToggle
Tested packaged SCuM 1 week before assembly
L2/L3/L4/L5
L2 has lower than expected current, but does appear to change on boot
L3-L5 did not appear to boot
Tested packaged SCuM ~4 months before packaging and assembly
possible mixup identifying SCuM before packaging
After adding headers/SMA connector to L11/L12/L13/L18/L31/L37/L43/L49
Confirmed to work under 3WB/optical bootloader
Transmits to and from SCuM to and from an OpenMote
Transmits IMU data over UART
L20/L21/L23/L28/L30/L32/L34/L35/L36/L38/L39/L40/L41/L42/L44/L45/L46/L47/L48/L50
Assembled by Digicom using low temperature solder and no pin headers or through-hole SMA connector as previous group of 12.
Before adding headers/SMA connector optical bootloader boot testing
L21/L23/L28/L30/L32/L34/L35/L36/L38/L41/L42/L44/L45/L46/L47/L48/L50
Booted using optical bootloader
Normal current profile for AllGPIOToggle
Tested packaged SCuM 1 week before assembly
L20/L39/L40
L20 Stays around 270 uA with VBAT + GND, 164 uA with VDDD also. Does not boot
L39
See delta of ~50 uA on boot as if a Tap board without VDDD, but see no change on boot with VDDD connected
Could just be poor connections by directly connecting wires
L40
19-20 mA with just VBAT + GND connected.
Normal 0.145mA when VDDD connected, but doesn't boot
Tested packaged SCuM ~2 weeks before packaging and assembly