Attendees

Minutes

@Fil Maksimovic
- discussion with @Austin Patel about while(1) statement, was able to get SCuM to receive more packets (OpenMote sending to SCuM)
- @Austin Patel discusses the fact that 4ms period was legacy code from working with Sarah
- full 16-channel TX and RX calibration using OpenMotes
- current work: working on minimalistic version of TSCH using the OpenMote
- next: propagate calibration from one SCuM to the next
- did AoA measurements for @Tengfei Chang , looks bad
discussion about nRF
- discussion about nRF PDR (dependent on packet length)
  - nRF->SCuM: 100%
  - SCuM->nRF: 25%
- with 100B packet, nRF didn’t receive anything
- root cause unclear, tried multiple things, no effect
  - varying 2MHz clock (chipping clock)
  - supply voltage on SCuM to below 1.8V to maybe change tone spacing
- @Kristofer PISTER the nRF can be the assistant to program and calibrate and UART interface to SCuM, but not the root of the network
@David Burnett
- discussion about combining different oscillators (10-100)
@Joshua Alexander
- about 10-100 SCuM board
- discussion about epoxy deformation
- some discussion with Mo and Quik-Pak
  - Mo indicated they didn’t take the board to 250C, Quik-Pak indicates epoxy holds up to 275C
  - discussion about temperature involved with putting headers on
- Josh shares Past Sulu Assemblies
@Thomas Watteyne
- training for Paris half marathon
- would like to talk about role of “team assistant”